Personalizovani natpis 33 – 3D štampano

Update 12/2/23Updated the anchor model with tighter tolerances. Results my vary depending on printer so scale as needed.Added a blank Lithophane that can be used instead of a second image if you don’t want the ornament to be double sided! Can be printed flat.This is a very simple double sided Lithophane ornament using one of the lights from your tree! The ornament spins easily and there is a spot for a picture on both sides. Or you can leave the back open/print a blank Lithophane if you only want one image.Print SettingsOrnament/AnchorI printed these at .2 layer heightThe bottom half of the ornament may need a tiny bit of support as there’s an overhang where the Lithophane sits. It’s less than a gram of filament but you may be able to get away without it depending on your printer.The top h