Personalizovani natpis 30 – 3D štampano
Personalizovano i imena

Personalizovani natpis 30 – 3D štampano

These are mainly for use with the lithophanes available on Gadunky.com(but work on anything that will fit in them). They hold the lithophane at an 80° angle for

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: RetromanIE

These are mainly for use with the lithophanes available on Gadunky.com(but work on anything that will fit in them). They hold the lithophane at an 80° angle for best viewing(the flat section with the curve should be facing the back).
Print with 100% infill in whatever material and colour you like(tested with PLA, PETG and ABS). A layer height of 0.2mm is a good balance between quality and print time on these.
The height of the lithophane must also be considered when using a stand. These have been designed to comfortably hold a lithophane with a height 1.75x the length of the stand. So the 180mm version should hold a lithophane with a height of 315mm(180mm+75%) without falling over. In practice it will hold a much taller lithophane than this, but we only recommend up to 1.75x the length.
If

Slično iz ponude