Dodatak za elektroniku – 3D štampano
Elektronika i DIY

Dodatak za elektroniku – 3D štampano

I was adding LED lighting to my IKEA Lack Enclosure and wanted a clean way to pass the cable outside the enclosure. I created this cable management grommet for

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
📩 Pošalji upit / naruči ili u DM na Instagramu
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Jmac

I was adding LED lighting to my IKEA Lack Enclosure and wanted a clean way to pass the cable outside the enclosure. I created this cable management grommet for this purpose. The grommet will fit into a 1/2 inch hole in the enclosure and the grommet cap will allow a cable up to about 3.5 mm in diameter.
Print instructionsThese are the settings I used for my prints.
Resolution: 0.20mm Quality
Material: PETG
Supports: None
Infill: 15%
Brim: None

Model: Cable Management Grommet for IKEA Lack Enclosure (1/2 inch hole), autor Jmac, licenca CC BY-SA 4.0. Fotografija je autorova; mi štampamo po ovom modelu u boji po vašem izboru.

Slično iz ponude