Držač 12x 2 – 3D štampano
Elektronika i DIY

Držač 12x 2 – 3D štampano

Holds 12x AA batteries. Prints upside down (load batteries from top) without supports.Note: this will NOT fit Duracell AA batteries. If you want to use Duracell

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Brianne

Holds 12x AA batteries. Prints upside down (load batteries from top) without supports.Note: this will NOT fit Duracell AA batteries. If you want to use Duracell (or similar), you’ll have to scale the X and Y down to 97%, but not the Z. This is because the batteries I used for mine (Amazon Basics and Eneloop) are slightly larger than typical.

Slično iz ponude