Toranj za kockice 3 – 3D štampano

A very minimal, yet apparently effective, cylindrical dice tower.
This was done because most of the other designs have parts that don’t really print well without supports. There is nothing tricky on this one: no overhangs and no angles shallower than 45 degrees. The walls are also quite thin to minimize material use and give a bit more “bounce” when a die hits a surface.
As it happens, my family is pretty tough on dice towers. After being knocked onto a hardwood floor a few times, the original design cylinder cracked. The revised design is very similar, but a tad improved with thicker walls… and I printed it with double walls to give more strength. It’s the version printed part white and part blue (because the white spool ran out just as it reached printing the slide that fits in the bas