Stalak za slušalice 9 – 3D štampano

This is a headset stand that clamps onto your desk. I have not printed the model, as I do not have a 3d printer yet, but if you do decide to print this model, please rate it and upload a photo of the model. Any feedback is highly appreciated!Recommended print settings:-30% gyroid infill (minimum recommended)-3 wall loops (minimum recommended)Print the stand on it’s side, you could add a 4mm brim for maximum security-ORIENTATION MATTERS!!! The teardrop hole must be pointing UP!.2mm layer height should be fine, the lower the better though.! Depending on the printer calibration, the screw may be harder to screw into the clamp for the first time, so you may have a difficult time using it right after printing.