Stalak za slušalice 17 – 3D štampano
Računari i gejming

Stalak za slušalice 17 – 3D štampano

This is a remix of the "Headset Stand" from "DecoPrint".The original is too large to fit on a 200x200mm bed. The original model was divided into a top and botto

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: TheoBr24

This is a remix of the “Headset Stand” from “DecoPrint”.The original is too large to fit on a 200x200mm bed. The original model was divided into a top and bottom part.You need 3x M4*30 screws and 3x M4 nuts.The ring insert can be found on the original model.If the top part still doesn’t fit on your print bed, make sure you disable “bed adhesion”, e.g. “Skirt” or “Brim”.

Slično iz ponude