Stalak za punjač 3 – 3D štampano
Nakit i dodaci

Stalak za punjač 3 – 3D štampano

It works fine and does as intended.Use your favorite print settings. A bit of support seems necessary.(I'm not too picky about the finish, so I used my Ender 3

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Bjørk

It works fine and does as intended.Use your favorite print settings. A bit of support seems necessary.(I’m not too picky about the finish, so I used my Ender 3 with PLA through a 0.4mm nozzle at: Layer height 0.3Extrusion width 0.6Speed 100 mm/sI used some support set to 60-something degrees. ) 

Slično iz ponude