Poklopac za ventilator 2 – 3D štampano

SummaryFinger/Fan protector for the black version of the Prusa i3 MK3 hotend fan (Noctua) without the rubber corners.Made extra thin with bolt countersinks and corner standoffs for close fit.FYI, I’ve discovered that having the fan cover installed causes the print to shift 3-4 mm to the right on the print bed. Under normal operation this is not an issue, but I recently needed to print something the full 250 mm width and it took me awhile to figure out why it was printing off the right side of the bed. So, I removed the grille, but I’ve since stuck my finger in the fan a couple of times (why I created it in the first place). Once done with my large prints the grill is going back on the first chance I get.Print SettingsPrinter brand:PrusaPrinter:i3 MK3Rafts:NoSupports:NoResolution:.20mmInfil