Personalizovani natpis 34 – 3D štampano

This is a calibration tile for finding the “maximum thickness” to enter into lithophane generators like lithophanemaker.com or 3dp.rocks.
Values of 3-4mm usually work well, but since every filament absorbs light differently, you might want to run a quick test before spending hours printing a whole lithophane only to find that it’s too dark to see anything or too light to get a nice contrast.
That’s where this print comes in.
Using only 5 grams of filament and printing in just 30 minutes using the settings below, it quickly gives you an idea how much light the filament absorbs at different thicknesses.
Features:

Each “block” is a different thickness, ranging from 0.5mm up to 7.0 mm. The number on each block gives the thickness in mm.

The numbers are cut 0.5 mm deep into the block. This g