Nosač za računar 44 – 3D štampano
Računari i gejming

Nosač za računar 44 – 3D štampano

This is a PCIe bracket on which a PiKVM setup can be fixed based on a Raspberry Pi Zero W + Lusya HC100 Ver:A01 HDMI to CSI bridge + 3cmx7cm pcb with ATX power

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Rolf Bakker

This is a PCIe bracket on which a PiKVM setup can be fixed based on a Raspberry Pi Zero W + Lusya HC100 Ver:A01 HDMI to CSI bridge + 3cmx7cm pcb with ATX power on/off + reset.
Check out the awesome PiKVM project at https://pikvm.org/
There are several different versions of the Lusya board, I used the Blackupgrade version: 45x30mm (the same width as PI ZERO, the same two holes), which can be found here:
https://de.aliexpress.com/item/4000102166176.html?spm=a2g0s.9042311.0.0.27424c4deJpKzB
The bracket can be mounted to the mounting plate with 3mm x 6mm or 8mm countersunk head screws.
The RPi Zero and Lusya HDMi-CSI bridge can be mounted with 2.5mm x 6mm cylinder head screws. The PCB can be mounted with 2mm x 6mm cylinder head screws.
I take the 5V power from the 5V Stanndby power of the ATX

Slično iz ponude