Računari i gejming
Nosač za računar 40 – 3D štampano
Remix of a remix here. First, I ran the bottom through netfabb which resolved a lot of errors. Second, I remixed the top to significantly short the screw pole c
Cijena na upit
Javi se — dogovorimo boju, veličinu i rok.
📩 Pošalji upit / naruči ili u DM na Instagramu
- 🎨 Boja po tvom izboru
- 📐 Veličina po dogovoru
- 🐧 Štampamo po porudžbini
- 📦 Dostava širom Crne Gore
Dizajn: sungo
Remix of a remix here. First, I ran the bottom through netfabb which resolved a lot of errors. Second, I remixed the top to significantly short the screw pole closest to the GPIO pins. This allows one to use a Pimoroni Fanshim inside the case.
The photo was printed in Fillamentum Vertigo Gray PLA at on “0.20mm Speed” profile in PrusaSlicer with 100% infill.
