Nosač za računar 10 – 3D štampano
Računari i gejming

Nosač za računar 10 – 3D štampano

This is a simple full-length PCIe bracket for the Dell PowerEdge H310 HBA / RAID controller.I mounted the card to the bracket with two short M3 bolts and nuts,

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
WhatsApp Viber

Cijena zavisi od veličine, boje i količine — zato je na upit. Javljamo se isti dan.

ili u DM na Instagramu
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: matmen

This is a simple full-length PCIe bracket for the Dell PowerEdge H310 HBA / RAID controller.I mounted the card to the bracket with two short M3 bolts and nuts, but you can also use an M4 bolt and screw directly into the plastic.With some case and mainboard combinations, the end that points towards the mainboard might be too thick, but it can be trimmed down easily with a pair of side cutters. Print SettingsMaterial: PLA worked fine for me, may want to consider a higher temp alternative thoSupports: Enabled, support enforcers only (see slicer screenshot)Orientation: Place part in slicer with the card mounting tabs touching the bed for optimal print quality

Slično iz ponude