Nosač za Pi – 3D štampano
Računari i gejming

Nosač za Pi – 3D štampano

Note!If you don't have the Pi 5 official case, then you probably don't need or want this remix. Just buy the official Pi 5 cooler instead and use the original m

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: morotsgurka

Note!If you don’t have the Pi 5 official case, then you probably don’t need or want this remix. Just buy the official Pi 5 cooler instead and use the original model. Print instructions:The top is printed with the top facing down, you might need some small tree supports for the fan-clips. But might print fine without them too.The bottom prints normally with the bottom facing down, no supports. Assembly is the same as the original model.

Slično iz ponude