Kuhinjski dodatak 2 – 3D štampano
Kuhinja i domaćinstvo

Kuhinjski dodatak 2 – 3D štampano

One of my hooks of the original design unfortunately broke when tearing off a paper towel. The second would not have held out much longer either. Perhaps the ba

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Melmac Alpha

One of my hooks of the original design unfortunately broke when tearing off a paper towel. The second would not have held out much longer either. Perhaps the back side, to which the Skadis hook is attached, was a bit too thin with 1mm. Therefore, I have made a remix with a back twice as strong.I also reinforced the hook from 4.9mm to 5mm so it sits tighter in the Skadis board and doesn’t slip out as easily as it did for me.And I narrowed the holder so that it is printable without supports.Thanks to @krisennerd for the original design.Thanks to @Qfrcy for the printable tear off bar.

Slično iz ponude