Korpa za računar – 3D štampano
Računari i gejming

Korpa za računar – 3D štampano

The instructions in the original are still generally applicable to this since not a lot has changed. There is a indent on the Cohesity drive holder that may req

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: jgodson

The instructions in the original are still generally applicable to this since not a lot has changed. There is a indent on the Cohesity drive holder that may require some tweaks when printing the 2.5″ version.Here are my relevant settings. I printed these in PLA and haven’t had issues, but there are some suggestions on similar models (including the original) to use PETG if your drives get too warm:Cohesity Caddy FrontProbably want to open this as a project in Prusaslicer so that you get all the relevant settings. See screenshot:No supportsNo brimI add a box modifier in the middle between the two larger holes. This is set to 0 top and bottom layers to allow the infill to come through. You can also just generally set it to 0 top and bottom layers, but I liked the way this looked a bit more.Co

Slično iz ponude