Figura 20 – 3D štampano

This is clicky rocker switch! Case and Spring parts are compatible with original “Fidget Clicking Wheel 2.0”.Print Settings:Material: PLA, PETGLayer height: 0.15 – 0.20mm  (For your information, I tested it at 0.30mm and it was quite tight due to the tolerance.)Supports: noPerimeters: 2Assembly: Before assembling, fit each wheel into its respective casing and ensure smooth rotation. If the rotation feels stiff, use a file to trim it as necessary.Finally, set the spring and make sure the wheel is engaged, then attach the opposite side of the case.Note:I recommend that attempting to make a conversion from the original “Fidget Clicking Wheel 2.0” use the hard spring.The feel varies greatly depending on the material, try it!My Other Fidget Toys:https://www.printables.com/@BaGooN/coll