Edukativni model 15 – 3D štampano
Edukacija i STEM

Edukativni model 15 – 3D štampano

This little marble machine uses 6mm Airsoft BB's for the balls. When they get to the bottom, just tap the little thwacker and send them back over the top to the

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: LoboCNC

This little marble machine uses 6mm Airsoft BB’s for the balls. When they get to the bottom, just tap the little thwacker and send them back over the top to the start. It’s actually a little more challenging than it looks! See how many balls you can keep going at the same time.Plus, it prints in one piece (except for the feet) and with no supports!Watch it go: Print SettingsPrinter:UDIORafts: NoSupports:NoResolution: 0.2mmInfill:15% Notes: Print OTTMM.STL plus four of the OTMM_foot.STL. The feet should press into the divots in the bottom of the marble machine, but if they are loose, secure them with a drop of superglue.After printing, you need to run some fine sandpaper or steel wool through the track to make it very smooth – the slighted bump will cause the balls

Slično iz ponude