Držač za kockice – 3D štampano
Gaming i hobi

Držač za kockice – 3D štampano

 A hexagonal DND dice tray with a compartment for holding your dice.Requires a decent sized bed (179 x 168mm), although you can always print it a little sm

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Joseph Duchesne

 A hexagonal DND dice tray with a compartment for holding your dice.Requires a decent sized bed (179 x 168mm), although you can always print it a little smaller to make it fit.Post-PrintingCut out adhesive backed felt (walmart craft section, dollar stores) and back the large compartment. You can cut paper to size, then tape the paper to the felt to make cutting easier. This makes the dice roll softer and slide less (which I find feels better).I also used 6 1″ square cork adhesive pads on the bottom for grip and to reduce noise/bounce (one in each “corner” underneath) 

Slično iz ponude