Držač za bar 13 – 3D štampano

This is an improved version of Dolce Gusto capsule holder: https://www.thingiverse.com/thing:2847560
You will need:

1x base (0.20 layer height or above)
1x ring
6x capsule holder

Depending on the total height you want:

220 mm height total:
1x slider with pins (110 mm)
1x slider with cover (110 mm)

200 mm height total (one piece, less gluing needed):
1x slider large with cover

Assembly instructions:

place base on the bottom
add ring on the base
in case you have 2 slider parts, glue them together
set slider part(s) upside down and glue all capsule holders
attach the glued part on the base, it should fit perfectly and rotate freely

Recommended layer height is 0.2, except for the base part which can go higher.

Category: Organization