Držač za 3D printer 29 – 3D štampano
3D printer pribor

Držač za 3D printer 29 – 3D štampano

This is a simple dual-bearing spool holder for the Elegoo Centauri and Centauri Carbon. Required hardware608 bearing, x2I strongly recommend using greased

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Chirimorin

This is a simple dual-bearing spool holder for the Elegoo Centauri and Centauri Carbon. Required hardware608 bearing, x2I strongly recommend using greased bearings. The grease provides some resistance which helps to slow down the spool when extrusion slows down or stops. A 608 bearing is 8mm X 22mm X 7mm. Printing instructionsPETG or better filament is recommended. PLA is not recommended because it will sag over time. All parts are provided in the recommended printing orientation.Paint supports on the holder as shown in this image (yellow area):The roller and pin do not need any supports. Support type: tree (manual)Wall Loops: 3Wall Order: Inner/Outer/InnerInfill: 10%-15% of your favourite type of infill. Assembly & installationInsert the bearings on

Slično iz ponude