Držač za 3D printer 19 – 3D štampano
3D printer pribor

Držač za 3D printer 19 – 3D štampano

I made this little clip for extra support for the original Side Spool Holder since without it it tends to bend after a couple weeks. Works with: https://ww

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Sunny Galeas

I made this little clip for extra support for the original Side Spool Holder since without it it tends to bend after a couple weeks. Works with: https://www.printables.com/model/776235-ender-3-v3-seke-side-spool-holder-less-gantry-wobb Infill: 15%Supports: No To Install, Remove the roller and take the Spool Holder off your printer, keep the metal thing still attached. Using a screw driver and “hammer”, slowly push the clip in. Make sure it is going down at the same rate on both sides until it sits a top of the Spool Holder.

Slično iz ponude