Dodatak za računar – 3D štampano
Računari i gejming

Dodatak za računar – 3D štampano

I could not find an extra-tall GPU anti-sag device, so I made my own. I went a little overboard, but it should be tall enough for even the biggest cases. I use

Cijena na upit Javi se — dogovorimo boju, veličinu i rok.
Naruči u DM Pošalji upit
  • 🎨 Boja po tvom izboru
  • 📐 Veličina po dogovoru
  • 🐧 Štampamo po porudžbini
  • 📦 Dostava širom Crne Gore

Dizajn: Andrew Leaver

I could not find an extra-tall GPU anti-sag device, so I made my own. I went a little overboard, but it should be tall enough for even the biggest cases. I use a Phanteks Enthoo Pro II, and the GPU sits roughly 220mm off the bottom of the case. It is just a simple locking jack stand design.Printed this in Prusa PETG. I got the threads to work with a -0.1mm offset on the three faces in Autodesk Fusion, but it could probably be a bit more. Got the tip from a comment on this video by jeremyodom2925. **v2  I added a bevel to match the GPU angles, and cut it a bit shorter to save plastic.

Slično iz ponude