Božićni Modla za kolačiće – 3D štampano

I run a cookie cutter 3D printing business and this is one of the sets we sell, these designs are inspired by commercial designs but I made these models by hand so its not just a simple copy-paste as most people would do. Suggestions:You can use PLA but I would strongly suggest PETG and also never use ABSThese are designed to be optimal for 0.6 nozzle but 0.4 will work too, you might want to adjust your z offset higher if using PETG to get the best top layer since if its very rough it will transfer onto the cookies.These should be washed very carefully since the layer structure of the prints makes ideal grounds for bacteria to live and multiply. If you print them with PETG you can wash them in hot water(below 70C) and if you can scrub them with a cleaning brush. Good luck, 73