3D model 9 – 3D štampano

Yet more DJI Mini/Mini 2 Landing Gear Extensions.These are light, about 5.5 g for all four.They add about an inch (25mm) to the height.I used PETg, but they should be fine with other materials.I used .20mm layers. Could have used .15, but why waste the time?For the front pair, I used a brim setting in Prusa Slicer because there is not much touching the bed. Clean out the fronts carefully because they fit rather tightly. Press them on with some pressure and remove by HOLDING THE ARM and using a fingernail to slide the tip off the arm. At first you should put them on and take them off until they loosen up a bit. Note that they only go on one way matching the curvature of the front arms.The rear extension do not need any brim, unless you have trouble with adhesion to the bed. When installing